ALLNET Point-to-Point Coax 8 Port Master Chassis/Amplifier EOC 200 zbh. EOC G.hn flush-mounted box/through box "ALL-GHN108S-200-UP socket

ALLNET Point-to-Point Coax 8 Port Master Chassis "ALL-GHN108M-Coax-200" without modules The distribution amplifier ALL-GHN108M-Coax is a highly integrated solution to provide a Gigabit network on 8 coaxial lines. Up to 8 G.hn modems deliver 750 Mbit or 1700 Mbit net per coaxial strand, depending on the model. A built-in power meter simplifies service during and after installation. Without compatibility to a cable network operator, even up to 1700 Mbit is available. Signal strength and skew can be digitally adjusted. If compatibility with a cable network operator is required, 750 Mbit are available. The ALL-GHN108M-Coax-200 takes care of all tasks such as filling, amplifying and splitting the TV signals as well as inserting the G.hn network data. Elaborate mounting boards / installations are not necessary. The chassis are available for EOC-Ethernet over COAX with 100MHz modules for DVB-C coexistence and as 200MHz with more bandwidth without DVB-C coexistence. Or explained differently. The EOC 100 and EOC 200 differ as follows: EOC 100 1 Gbit/650 Mbit (gross/net) see (Part No. 193132) EOC 200 2 Gbit/1.7 Gbit (gross/net) see (Part No. 221624) EOC 100 and EOC 200 - What's behind them ! The EOC 100 uses the frequency band 2-87 MHz for the transmission of data and can provide the broadband cable signal (DVB-C) from 88 to 860 MHz, so that the cable connection of your provider can still be fully used. The EOC 200 uses a frequency band of 2-199 MHz. Ideal for operators of a headend . Technische Daten ALL-GHN108M-Coax-200 Gain 33 dB (internal 48 dB) Bandwidth 1.5 GHz Ripple 1.5 dB Integrated amplifier 125 dBµV Noise figure 4 dB Noiseflor -170 dBm/Hz Integrated 8-fold splitter 8 outputs with max. 108 dBµV Return channel lock High pass and low pass filter Up to 8 G.hn modules Internal performance meter 50 dbµV to 110 dbµV Up to 64 participants/EOC1700 Remote power supply 24 V up to 40 EOC1700 Digitally adjustable: 8x 31dB attenuator (0.5 dB steps) skew correction (0-3-6-9 dB) Important: setting the output power The total band power (approx. 90 transponders) is 19.5 dB higher compared to the output power of a single transponder determined with a measuring device! You must take this into account when adjusting the total band power.   Example 1 1 transponder: 80.0 dBµV measured 90 transponders: 99.5 dbµV tape power   The LED display on the device shows 99 dBµV. Result: The input signal can be amplified (only) by 10 dB.   Example 2 1 transponder: 90.0 dBµV measured 90 transponders: 109.5 dbµV tape power   The LED display on the device shows 109 dBµV. Result: The input signal cannot be further amplified. Consideration for 5 in-wall sockets in the line: Good TV reception requires 60 dbµV - 75 dbµV at the input. One in-wall socket EOC 1000/EOC 2000 has a transmission loss of 2-3 dB and a decoupling loss of 18 dB. The AMP X8 delivers a maximum of 110 dbµV per strand.   After 5 EOC 1000/EOC 2000 in-wall sockets connected in a row is the total attenuation:   4x3 dB Transmission loss + 18 dB Decoupling attenuation + 4x1-2 dB Attenuation in the coaxial cable = 34-38 dB Total attenuation   Then an optimal setting on the ALL-GHN108M-Coax-200 would be: 60 bµV-65 dbµV + 38 dB = 98-103 dbµV. At the first in-wall socket, 12 dB would then arrive at the output, i.e. 72-77 dbµV.

Highlights: Frequency range: 2 - 199 MHz Network standard: G.hn Hardware encryption: AES 128-bit Quality of Service: VLAN/TOS/Packet Classifier/ Gross data rate: 2000 Mbps max. Net data rate: 1700 Mbps max. incl. power supply for the optional EOC sockets 200MHz max. EOC sockets can be operated per module in the chassis The G.hn module is used to extend an existing AMP ALL-GHN108-200 distribution amplifier in conjunction with EOC 200 flush-mounted boxes. Up to eight G.hn modules can be installed per distribution amplifier. Only G.hn modules of the same type (200MHz) can be installed per distribution amplifier. The G.hn plug-in module enables an additional coaxial line to be integrated, which is available in the line with EOC 100MHz flush-mounted sockets for picking up network data and/or DVB-C signals. This is also known as DVB-C coexistence. ATTENTION: This is only the 200MHz g.hn module, the chassis/amplifier Art. 221624 is also required. see accessories  

The EOC WLAN is an in-wall socket which supports the simultaneous transmission of Internet and Cable TV on an existing coax cable network. The EOC WLAN in-wall socket is a "C"able pass-through socket with 2 antennas (2T2R) and integrated 2.4 GHz WiFi (Wi-Fi 4 2x2 802.11n). The coax socket provides a broadband cable signal in the range of 108 - 860 MHz, which can be used with a standard receiver. The TV signal is provided via the TV socket, the network dates are transmitted via WLAN. Interconnection of individual in-wall sockets is done automatically. The EOC WLAN is being powered via remote supply by an ALL-GHN108M-Coax-200  . Therefore, it can supply four subsequent EOC 100 and/or EOC 200 and/or EOC WLAN. The EOC WLAN can be installed in a single flush-mounted box as well as in a multiple flush-mounted box. Each EOC WLAN can exchange data with any other flush-mounted box. Recommended application: Building upgrade with gigabit Ethernet with existing coaxial cabling and on a limited budget. Home users Small company networks Hotels Hospitals Sanatoriums Retirement homes Renovation of old buildings Coax C-throughput in-wall socket Can be integrated into single outlets and multiple outlets Frequency range 2 – 199 MHz Network standard: G.Hn Data rate Gross: 2000 Mbps Data rate Net: 1700 Mbps Attenuation 300 – 860 MHz: -2 dB (16 db coupling) Attenuation 300 – 860 MHz: -3 dB (10 db coupling) Coupling: 10 db or 16 dB Hardware encryption : AES 128-bit Quality of Service: VLAN/TOS/Packet Classifier/Virtually perfect transmission with IPTV Remote service: TR-069 remote management (option) Only suitable for DVB-C wiring Satellite wiring is not supported     Technischen Daten: Software: openWRT 21.02.0 CPU: MIPS24KEc 580 MHz RAM: 64 MB RAM Flash: 32 MB Crypto: AES 128/256 Wi-Fi4: Datenrate 2x 150 Mbit/s (brutto) 2x2 802.11n Freqency: 2.4 GHz Antenna: 2T2R

Mean Well power supply GST60A24-P1J DC 24V, 2.5A, 60 Watt Voltage: 90-264VAC, 47~63Hz Größe: 125*50*31,5mm For further details please refer to the data sheet

Mean Well Netzteil GST25E24-P1J   DC 24V, 1,04A, 25 Watt Voltage: 85-264VAC, 47~63Hz Größe: 79*54*33mm weitere Details bitte dem Datenblatt entnehmen

250V/10A,3x0,75mm², PRODUKT INFORMATIONEN: Anschluss Seite A : Schutzkontakt Stecker gewinkelt Anschluss Seite B : IEC-C13 Buchse gerade Kabellänge (m) : 1 Farbe : schwarz Besonderheiten : - Kaltgeräte Buchse gerade und Schutzkontakt Stecker abgewinkelt